Holder with
lock.
Active holder with cig-plug and tilt swivel. Fits for
devices with original skin. 2 keys included. With USB Host.
This holder is to be used when you want to secure your
Tab Active Pro and still have it easy accessable.
The active holder guarantees a neewly charged battery
at all times. 2 A charging. Charging via pogo plug.
Easy-switching system:
The easy-switching system enables you to upgrade the
holder only, and keep the installed cables. It saves you a lot of time! When
upgrading to a new device, you do not longer need to make a full installation.
Same goes for maintenance in case of warranty or damage. You simply disconnect
the holder from the charging cable via the Molex 6-pin quick connector, and
then connect the new holder. The switch is done in a few seconds.
The holder is also perfect for use in stores, at
exhibitions and any place where you want to use your Tab Active Pro without
having it easy removable. The holder is equipped with a lock. In order to
remove the Tab Active Pro from the holder you need the key, two keys are
included. The holder is mounted onto a tilt swivel. This mean that you can adjust the
angle in order to avoid light reflection on the screen. You can easily switch
between portrait and landscape mode by turning the holder into desired
position.
Tablets should not be installed onto a car's dashboard if blocking the view
or key controls. ProClip is designed for use with smaller devices like
smartphones. If you want to place a tablet onto a dashboard, each combination
of tablet-car must be examined in detail by yourself in order to determine if
such an installation is possible in the specific case. Brodit will not give any
recommendations for such installations. An installation of a tablet onto a
vehicle's dashboard is always done on the customer's own responsibility. Brodit
recommends using tablets on the car's headrest, installed onto a Brodit
headrest mount.